Forms Glitch

[rmsmeltz]

I am using a REFROW column to add entries to the parent form and when the form view to add the boxes is primary, it shows the box label, but when I change it to a REF view and access it through the pallet form, the box label column is not visible. I have checked all views and slices linked to the table and ensured the column is checked to “show”. I cannot figure out why it is not visible. Any suggestions?

[Marc_Dillon]

Is there a valid_if?

[rmsmeltz]

Yes. It checks to make sure the shipment ID from the 2D barcode matches the shipment ID in the box label

[Marc_Dillon]

Ok, so what is the valid_if expression?

As John pointed out, the 2 form Views you showed are different Views. Were you aware of that? If not, that’s likely part of your issue. If so, then why are you showing 2 different views, your problem description is a bit confusing.

[WillowMobileSys]

rmsmeltz:

and access it through the pallet form, the box label column is not visible

I notice the View name in the image is “Pallets 2_Form”. Make sure you are checking the correct view OR if “Pallets 2…” was created by mistake (which I have done many times), remove it and then verify the correct Form is launching.