I am using a REFROW column to add entries to the parent form and when the form view to add the boxes is primary, it shows the box label, but when I change it to a REF view and access it through the pallet form, the box label column is not visible. I have checked all views and slices linked to the table and ensured the column is checked to โshowโ. I cannot figure out why it is not visible. Any suggestions?
Is there a valid_if?
Yes. It checks to make sure the shipment ID from the 2D barcode matches the shipment ID in the box label
Ok, so what is the valid_if expression?
As John pointed out, the 2 form Views you showed are different Views. Were you aware of that? If not, thatโs likely part of your issue. If so, then why are you showing 2 different views, your problem description is a bit confusing.
I notice the View name in the image is โPallets 2_Formโ. Make sure you are checking the correct view OR if โPallets 2โฆโ was created by mistake (which I have done many times), remove it and then verify the correct Form is launching.
User | Count |
---|---|
35 | |
31 | |
30 | |
19 | |
18 |