Hi everyone,
I’ve enabled the Auto Re-Open switch for a form, but it doesn’t work. What could it be?
Thanks!
Solved! Go to Solution.
Find the configuration for the Inventarios Hoy Form and set it to auto-reopen.
May I ask what exactly happens when you save the form?
Hi Aleksi,
It goes back to the detail view.
Does your form have any actions attached to it? Is so, what do they do?
Hi Steve,
It only has edit and add, nothing else.
What about the form’s Finish view property?
It is in Automatic
When you’re in the form from the emulator, is the view identified at the bottom of the emulator the same view you’re configuring to auto-reopen?
Ok you’re getting there… The title says “Inventarios Hoy Form” which stands for a slice I have. The problem is I cannot select it in the finishing view because it’s not there.
Find the configuration for the Inventarios Hoy Form and set it to auto-reopen.
Perfect! Didn’t knew there was a a seperate view for the slices. Thanks again Steve!
User | Count |
---|---|
43 | |
28 | |
23 | |
14 | |
14 |