Auto Re-Open

[AlejandroCamach]

Hi everyone,

I’ve enabled the Auto Re-Open switch for a form, but it doesn’t work. What could it be?

Thanks!

[Aleksi]

May I ask what exactly happens when you save the form?

[AlejandroCamach]

Hi Aleksi,

It goes back to the detail view.

[Steve]

Does your form have any actions attached to it? Is so, what do they do?

[AlejandroCamach]

Hi Steve,

It only has edit and add, nothing else.

[Steve]

What about the form’s Finish view property?

[AlejandroCamach]

It is in Automatic

[Steve]

When you’re in the form from the emulator, is the view identified at the bottom of the emulator the same view you’re configuring to auto-reopen?

[AlejandroCamach]

Ok you’re getting there… The title says “Inventarios Hoy Form” which stands for a slice I have. The problem is I cannot select it in the finishing view because it’s not there.

[Steve · Accepted solution]

Find the configuration for the Inventarios Hoy Form and set it to auto-reopen.

[AlejandroCamach]

Perfect! Didn’t knew there was a a seperate view for the slices. Thanks again Steve!